Qwickset Push Button Door Lock Blicks Red And Doesnt Work

The keypad flashes at the same time.

Qwickset push button door lock blicks red and doesnt work.

The spindle is spring loaded and will retract back when released. If this doesn t work you need to remove the knob again. Press the button once more. Press the latch bolt.

Make sure the turnpiece is in the vertical position. Hold the handleset on the exterior side of the door and make sure the round edge of the spindle faces the door edge. Keep holding the button for 30 seconds until the lock beeps and the status led flashes red. The door handing process was not executed during installation.

Electronic locks are operated by an electronic keypad or touchscreen and have a back up keyway. Inspect the inside for signs of rust. When a user attempts to enter a pin code when the lock is in lock out mode the status indicator flashes red and blue. If it is not pull the spindle out and rotate 180 degrees.

Here are the instructions for the door handing. Spray the locking mechanism with liquid graphite to lubricate. Hold button until the latch bolt starts moving on its own. Enter your home with a personalized access code and lock your door with the touch of a button.

All code lock out mode is a feature in which the lock rejects all user codes. Press and hold the lock button while installing battery pack. On my smartcode 909 910 the lock beeps the keypad flashes red and the door cannot lock. Press and hold the a or program button while reinserting the battery pack.

The master pin code can still be used to unlock the door. Press the lock button on the keypad then enter the security code to resynchronize the bolt.